Paint quantity calculator
Enter the size of a room and get the gallons of wall paint to buy, after taking out doors and windows.
Result
3 gallons
About 2.09 gallons for 2 coats, rounded up.
- Wall area before openings: 416 sq ft
- Doors and windows taken out: 50 sq ft
- Wall area to paint: 366 sq ft
- Coverage used: 350 sq ft per gallon
An estimate for walls only. It does not cover ceilings, trim, doors, primer, or extra paint for rough or unpainted surfaces.
Formula
area to paint = wall area − (doors × 20) − (windows × 15)
gallons = area to paint × coats ÷ coverage per gallon
gallons to buy = gallons, rounded up to a whole gallon
Assumptions and their sources
- The room is a rectangle with flat walls of one height. For an L-shaped room, run the calculator once for each rectangle and add the results.
- A door is 20 square feet and a window is 15 square feet. These are the averages Behr gives in its guide How Much Exterior Paint Do I Need? (read November 16, 2026). Behr states them for exterior estimating. This calculator applies the same averages indoors. If your windows are much larger, enter more of them.
- Coverage defaults to 350 square feet per gallon. Coverage is set by the manufacturer for each product, and it varies more than most people expect. See the table below.
- Two coats unless you change it. One coat can be enough when repainting the same color. Follow the label for the product you buy.
| Product and document | Sq ft per gallon |
|---|---|
| Sherwin-Williams Emerald Interior Latex Satin, product data sheet (11/2023) | 350 to 400 |
| Benjamin Moore Regal Select Interior Semi-Gloss N551, technical data sheet (06/2025) | 400 to 450 |
| Behr interior paints, guide How Much Interior Paint to Buy | 250 to 400 |
Worked example
A bedroom is 14 feet long and 12 feet wide with 8 foot walls, one door and two windows. It gets two coats of a paint that covers 350 square feet per gallon.
- Wall area: 2 × (14 + 12) × 8 = 416 square feet.
- Openings: 1 × 20 + 2 × 15 = 50 square feet.
- Area to paint: 416 − 50 = 366 square feet.
- Gallons: 366 × 2 ÷ 350 = 2.09 gallons.
- Rounded up: 3 gallons.
In a case like this, where the answer is just over a whole number, two gallons plus one quart would also cover it. A quart is a quarter of a gallon. The calculator rounds up to whole gallons because running short in the middle of a wall is the worse mistake.
Why coverage matters more than anything else
The three documents in the table above span 250 to 450 square feet per gallon. For the bedroom in the example, that is the difference between 3 gallons and 2. The number on your can is the one to use, so check the label or the product data sheet before you settle on a quantity, and change the coverage setting to match.
Stated coverage also assumes a smooth, previously painted surface. New drywall, bare wood, patched areas and textured walls take up more paint, and a strong color change may need an extra coat or a primer. The manufacturer's data sheet for a product normally says which primer it expects and what surface the coverage figure applies to.
Measuring the room
Measure the length and width along the floor, wall to wall, and round each to the nearest half foot. Measure height from the floor to the ceiling, not to the top of the baseboard. Closets that will be painted count as their own small rooms. Count only the doors and windows in the walls you are painting, and leave out any opening you plan to paint around, such as a wide archway, by entering it as a door.
If only some walls are being painted, such as one accent wall, the simplest approach is to work it by hand with the formula above: wall length times height, less the openings, times coats, divided by coverage.
What this estimate does not cover
- Ceilings. A flat ceiling is length × width, and it usually takes a separate ceiling paint.
- Trim, baseboards and doors, which are normally painted in a different finish and bought in quarts.
- Primer.
- Extra paint kept for touch-ups later. Many people keep the leftover from the last gallon for this.
- The price of the paint. Prices vary widely by product line and are not estimated here.
Paint that has been tinted usually cannot be returned, so it is worth checking the measurement before you buy. If the job needs more than one gallon of the same color, mixing the cans together in a larger bucket before starting keeps the color even from wall to wall.