Cost data library
One table per job. Each shows a low, typical and high figure, the unit, the sources and the date the figures were last checked.
This library collects the cost tables that the guides on House Care Costs are built on. A table is a small thing, but it is the part of the site that takes the most checking. Each one covers a single job or purchase, such as replacing a furnace or a water heater, and breaks it into the lines that actually differ in price, for example by equipment type or by size.
Each line shows three figures. The low and high figures mark the ends of the range that the sources report for a standard version of the job. The typical figure is where those sources cluster. Unusual conditions are left out of the range and described in the matching guide. Every table states its unit, says whether the figures are national or regional, and lists at least three sources with the date each was read. If fewer than three sources exist, the table carries a limited-data note.
The figures are planning estimates and not quotes. They are reviewed at least every 6 months, and the as-of date on each table shows when that last happened. The full method, including how quotes gathered by the editor are used, is on the methodology page.
Tables
| Table | Section | Typical range | As of |
|---|---|---|---|
| Furnace replacement cost by fuel type and efficiency | Heating and cooling | $1,480 to $7,625 | November 16, 2026 |
| Roof replacement cost table: installed price per square | Roof and exterior | $132 to $1,729 | November 16, 2026 |
| Water heater replacement cost by type | Plumbing and water | $902 to $6,400 | November 16, 2026 |