housecarecosts

Exterior paint: how many gallons and how long it lasts

At a glance

Typical cost
$43 to $80 per gallon for exterior paint
How often
Every 6 to 20 years on wood siding, by wood and coats
DIY or hire
DIY or hire

Prices are Home Depot list prices for five 1-gallon exterior paints seen on November 16, 2026.

Divide the wall area you are painting by the coverage printed on the can, then multiply by the number of coats. Behr's exterior paint guide (2026) says one gallon covers 250 to 400 square feet in one coat. On that range, 1,400 square feet of siding takes 4 to 6 gallons per coat.

How long the job lasts depends on the surface under the paint and the number of coats. The USDA Forest Products Laboratory's Wood Handbook chapter on finishing (2021) puts a primer and two topcoats at 6 to 20 years on wood siding, depending on the wood and its texture. A primer and one topcoat lasts about half as long.

The gallon estimate, step by step

Behr (2026) lays out the measuring in this order.

  • Body. Measure the perimeter of the house and the wall height from foundation to roofline, leaving out gables. Multiply the two.
  • Gables. Multiply each gable's width by its height and divide by two. Add the results to the body figure.
  • Deductions. Subtract windows and doors. Behr (2026) uses 15 square feet for an average window and 20 square feet for an average door.
  • Trim and gutters. Behr (2026) treats average trim as 6 inches wide, so total trim length times 0.5 gives square feet. One linear foot of gutter counts as about one square foot. Its shortcut: one gallon of trim paint for every eight gallons of body paint.
  • Coats. Multiply by the number of coats, then divide by the coverage on the label.

A worked example, using Behr's averages and this article's own arithmetic: a house 40 feet by 40 feet with 9-foot walls has 1,440 square feet of wall. Twelve windows and two doors remove 220 square feet. Two gables, each 24 feet wide and 6 feet high, add 144. That leaves 1,364 square feet. At 250 to 400 square feet per gallon, one coat takes 3.4 to 5.5 gallons and two coats take 7 to 11 gallons, plus one or two gallons for trim.

Behr (2026) adds that porous, rough, textured or previously unpainted surfaces need more paint, as does a dramatic color change. The site's paint calculator is built for interior rooms, but the same formula applies outdoors if you enter one wall at a time.

Coverage and coats on the label

Coverage is not the same from one can to the next, and the manufacturers do not agree on how many coats a repaint needs.

PaintCoverage per gallonCoats the maker recommendsSource
Any Behr paint250 to 400 sq ftDepends on surface and color changeBehr 2026
Behr Dynasty Exterior, satinUp to 400 sq ft2Home Depot listing, Nov 16, 2026
Sherwin-Williams Duration Exterior, satin250 to 300 sq ft1 for a repaint, 2 on new or bare surfacesSherwin-Williams data sheet, March 2026
Benjamin Moore Regal Select Exterior, flat300 to 400 sq ft1 or 2Benjamin Moore 2026

Use the low end of the range for the estimate. The Sherwin-Williams painting FAQ (2026) calls 400 square feet a theoretical figure, because surface texture and the paint left in rollers and brushes are not part of the calculation. On the example house, Duration's 250 to 300 square feet per gallon works out to 4.5 to 5.5 gallons for one coat.

How long exterior paint lasts, by surface

The Forest Products Laboratory (2021) compiled expected service life from the observations of many researchers, for an average location in the contiguous United States. The figures below assume a primer and two topcoats.

SurfacePaintSolid-color stain
Cedar or redwood siding, saw-textured15 to 20 years10 to 15 years
Cedar or redwood siding, smooth, vertical grain10 to 15 years8 to 12 years
Cedar or redwood siding, smooth, flat grain8 to 12 years6 to 10 years
Pine, fir or spruce siding, saw-textured8 to 12 years8 to 10 years
Pine, fir or spruce siding, smooth6 to 10 years6 to 8 years
Plywood, saw-textured8 to 12 years6 to 10 years
Plywood, sanded4 to 8 years4 to 6 years
Hardboard siding8 to 12 years6 to 10 years
Oriented strandboard4 to 5 years4 to 5 years

Source: USDA Forest Products Laboratory, Wood Handbook, Table 16-2 (2021). The table's footnote says a primer and one topcoat cuts these figures to about half, and that dark colors may fade within a few years.

Sun exposure moves the number as much as the wood does. The same chapter (2021) says paint on the shaded side of a building often lasts twice as long as paint on a fully exposed, sunny side, so the walls of one house do not need painting on the same schedule.

Paint type matters too. A Forest Products Laboratory FinishLine sheet, Paint, Stain, Varnish, or Preservative? (2013), says acrylic latex resists sunlight better than oil-based paint and weathers more slowly.

For factory-finished fiber cement, James Hardie (2026) gives its ColorPlus finish a 15-year limited warranty against peeling, cracking and chipping. The Forest Products Laboratory (2021) reports the same 15-year figure as a common guarantee from factory finishers of wood siding. No sourced service-life figures were found for field-applied paint on stucco, vinyl or aluminum siding.

Where the lifespan figures disagree

The published numbers for paint on wood range from 7 years to 30.

  • The FinishLine sheet (2013) lists the life span of paint as "7+ years".
  • The Wood Handbook (2021) gives 6 to 20 years by surface, says a three-coat system should last 20 years, and reports that many three-coat systems in the laboratory's own tests have lasted 30 years.
  • An older Purdue University Extension bulletin co-written with the Forest Products Laboratory, NCR-133 (1988), says one topcoat should last four to five years and two topcoats up to 10 years.

The 1988 figures predate the acrylic paints the 2021 handbook describes, which explains part of the gap. The rest is the number of coats and the wood.

Warranty wording is a separate matter. Sherwin-Williams (2026), Benjamin Moore (2026) and the Home Depot listing for Behr Dynasty (2026) each state a lifetime limited warranty. None of those product pages states a service life in years, so a lifetime warranty is not a repaint interval.

Repaint, spot-repair or wait

Age alone does not decide it. The Wood Handbook (2021) says to refinish when the old finish has worn thin and no longer protects the wood, and warns against painting too often.

What you seeWhat the source saysDecision
Topcoat worn thin, primer starting to showReapply one or two topcoats after washing (FPL 2021)Repaint that side
Paint sound but dirty or discolored with mildewWash it. It does not need repainting (FPL 2021)Wait
Chalk wipes onto a hand or clothClean it. If paint still wipes off after cleaning, reprime before topcoating (FPL 2013)Wait, or prime and repaint
A few blisters in recent paintLet them dry a few days, scrape, sand the edges and paint the area (FPL 2013)Spot-repair
Peeling to bare wood outside a bathroom or kitchen, or near flashingMoisture is the most common cause of early failure. Fix the source first (Purdue 1988; FPL 2013)Fix moisture, then spot-repair
New paint peeling off old paint within a yearIntercoat peeling, usually from repainting over a dirty surface (FPL 2021)Clean or prime, then recoat
Tape test pulls old and new paint off togetherOld paint is poorly bonded and must be removed before repainting (FPL 2021)Strip and repaint
Cracks across the grain in thick old paintRemove the old paint and refinish bare wood (FPL 2021)Strip and repaint
Wood soft and spongyIt will never hold paint. Replace it (FPL 2013)Replace the board first
Walls under porches, eaves and deep overhangsRepainting every other time usually performs adequately (FPL 2021)Wait a cycle

Sources: USDA Forest Products Laboratory, Wood Handbook Chapter 16 (2021) and Why House Paint Fails (2013); Purdue University Extension NCR-133 (1988).

Hire a painting contractor for any wall that cannot be reached from the ground or a low step, including second stories, gables and anything needing scaffolding. Homes built before 1978 fall under the EPA's Renovation, Repair and Painting rule (2026), and work that disturbs old paint there should go to an EPA-certified firm.

What a gallon costs in November 2026

These are list prices for one-gallon cans of white satin exterior paint, seen at Home Depot on November 16, 2026. The site notes that local store prices may vary.

Paint (1 gallon, satin)List priceSeller, date seen
Glidden Premium Exterior$42.98Home Depot, Nov 16, 2026
Behr Premium Plus Exterior$49.98Home Depot, Nov 16, 2026
Behr Ultra Exterior$61.98Home Depot, Nov 16, 2026
Behr Marquee Exterior$69.98Home Depot, Nov 16, 2026
Behr Dynasty Exterior$79.98Home Depot, Nov 16, 2026

At those prices, the 7 to 11 gallons of body paint in the worked example cost $301 to $880, before trim paint, primer and supplies. Sherwin-Williams (2026) shows prices only after sign-in, and Benjamin Moore (2026) lists Regal Select Exterior as not available for purchase online, so neither brand has a published list price to compare.

What to check before deciding

  • Walk each side separately. South and west walls wear first, and the Wood Handbook (2021) suggests two topcoats on those sides and a single topcoat elsewhere when two coats everywhere is not practical.
  • Wash a test patch. If the wall looks sound once the dirt, mildew and chalk are off, it can wait.
  • Run the tape test in several spots before committing to scraping or stripping. The Wood Handbook (2021) describes pressing an adhesive bandage firmly onto the paint and snapping it off. Paint on the tape means a poor bond underneath.
  • Trace every peeling area to a moisture source: gutters, flashing, caulk joints, or humid rooms behind the wall.
  • Count the existing coats where paint has chipped. The Wood Handbook (2021) warns that too many coats can eventually lead to adhesion failure of the primer.
  • Check the forecast against the label. The Wood Handbook (2021) says to apply latex paint at 50°F or warmer with temperatures holding for 24 hours, while the Sherwin-Williams Duration data sheet (2026) allows application down to 35°F.

Work out your own numbers

Paint calculatorLive
Your room

Result

3 gallons

About 2.09 gallons for 2 coats, rounded up.

An estimate for walls only. It does not cover ceilings, trim, doors, primer, or extra paint for rough or unpainted surfaces.

Sources

  1. Behr, How Much Exterior Paint Do I Need?. Accessed November 16, 2026.
  2. USDA Forest Service, Forest Products Laboratory, Wood Handbook (FPL-GTR-282), Chapter 16: Finishing Wood. Accessed November 16, 2026.
  3. USDA Forest Service, Forest Products Laboratory, FinishLine: Paint, Stain, Varnish, or Preservative? It's Your Choice. Accessed November 16, 2026.
  4. USDA Forest Service, Forest Products Laboratory, FinishLine: Why House Paint Fails. Accessed November 16, 2026.
  5. Purdue University Extension, NCR-133 Paint Failure Problems and Their Cure. Accessed November 16, 2026.
  6. US EPA, Lead Renovation, Repair and Painting Program. Accessed November 16, 2026.
  7. Sherwin-Williams, Duration Exterior Acrylic Satin K33-Series product data sheet 102.14B. Accessed November 16, 2026.
  8. Sherwin-Williams, Duration Exterior Acrylic Coating product page. Accessed November 16, 2026.
  9. Sherwin-Williams, Painting FAQs. Accessed November 16, 2026.
  10. Benjamin Moore, Regal Select Exterior Flat product page. Accessed November 16, 2026.
  11. James Hardie, Frequently Asked Questions. Accessed November 16, 2026.
  12. The Home Depot, BEHR PREMIUM PLUS 1 gal. Satin Enamel Exterior Paint and Primer listing and price. Accessed November 16, 2026.
  13. The Home Depot, BEHR ULTRA 1 gal. Satin Enamel Exterior Paint and Primer listing and price. Accessed November 16, 2026.
  14. The Home Depot, BEHR MARQUEE 1 gal. Satin Enamel Exterior Paint and Primer listing and price. Accessed November 16, 2026.
  15. The Home Depot, BEHR DYNASTY 1 gal. Satin Exterior Paint and Primer listing, specifications and price. Accessed November 16, 2026.
  16. The Home Depot, Glidden Premium 1 gal. Satin Exterior Latex Paint listing and price. Accessed November 16, 2026.